Nanosil

Beneath the surface, this waterproofing chemical provides a hydrophobic barrier and seals out moisture while retaining a strong chemical bond with the substrate. 

HOW TO USE

• Clean the surface

• Apply with brush/spray/Roller one vertical & horizontal coat at the same time on surface

• Allow it to cure for 4 hours

NANOSIL + PAINT APPLICATION

• Clean/wash the surface properly

• If any cracks are found, Fill cracks with cracksil

• Apply first coat of Nanosil

• After 4 hours, Mix 4 litre Paint + 1.5 Litre Nanosil & apply a horizontal coat on the surface, Once dry apply a vertical coat 

• After dry, apply the final coat with Nanosil

BENEFITS

• Hydrophobic

• UV resistant

• IR resistant

• No need to apply primer

• Reduces heat conductivity

• Solvent-free and low VOC

• Can be applied on any surface

Nanosil can apply on any surface such as

• Internal/External plaster wall

• Internal/External concrete wall

• On Bricks, Marble, Wood, PVC Pipe, FRP Sheet, Cement Sheet, GI Sheet, etc.

• On the terrace any surface such as China Mosaic, RCC, PCC, Tiling, etc.

Typical Coverage Rates:

The coverage varies based on texture and porosity. A small amount of Nanosil waterproofing chemical is always applied to check the surface porosity. Its unit is measured in terms of square feet per liter as mentioned below:

• Porous Surfaces: 50–75 Square feet.

• Semi-Porous Surfaces: 75–100 Square feet.

• Non-Porous Surfaces: 100–120 Square feet.